-40%
Arc Flywheel Puller 7250

Arc Flywheel Puller 7250

$ 17.15

Availability: 41 in stock
  • Brand: ARC Racing
  • Return shipping will be paid by: Buyer
  • Condition: New
  • Item must be returned within: 30 Days
  • Manufacturer Part Number: 7250
  • Refund will be given as: Money Back
  • Returns Accepted: Returns Accepted

    Description

    At OMB Warehouse, we strive to provide the greatest selection and quality of parts for your outdoor power equipment.Need other parts to complete your project? Check out our huge catalog - we have what you need.This flywheel puller is designed for those who don't want to use the "knocker" method to remove their flywheel. Works with:
    ALL ARC Flywheels with Steel Adjustable Timing Hubs
    PVL Clone flywheel
    Raceseng Flywheels
    To use, install the threaded rods into clean and lubricated puller holes on hub or flywheel face. Be sure to thread the rods in fully. Slide the puller block over the threaded rods and screw the nuts down evenly. Tighten the nuts evenly back and forth in 1/2 turn increments
    ARC Flywheel Puller
    At OMB Warehouse, we strive to provide the greatest selection and quality of parts for your outdoor power equipment.
    Need other parts to complete your project? Check out our huge catalog - we have what you need.
    This flywheel puller is designed for those who don't want to use the "knocker" method to remove their flywheel.
    Works with:
    ALL ARC Flywheels with Steel Adjustable Timing Hubs
    PVL Clone flywheel
    Raceseng Flywheels
    To use, install the threaded rods into clean and lubricated puller holes on hub or flywheel face. Be sure to thread the rods in fully. Slide the puller block over the threaded rods and screw the nuts down evenly. Tighten the nuts evenly back and forth in 1/2 turn increments until the flywheel pulls off. Stubborn flywheels may require that you hit the center of the puller block with a hammer once significant pressure is applied by tightening the nuts. Be careful not to strike the threaded rods (use a spacer if necessary) and NEVER hit the flywheel itself with a hammer.
    Heat as low as 300 ° will damage the rare-earth magnet in flywheels, so don't use a torch!
    ARC is not responsible for any damage you cause to any flywheel removed with this tool, so be careful!
    We do not accept returns on any electrical components. If you're unsure if the item is an electrical component, please contact us.